- #Canon ip3000 printer turning off by itself install
- #Canon ip3000 printer turning off by itself driver
If the supplied voltage and rating voltage do not match, do not plug the printer back in again, as damage may occur.
If not, turn off the power and unplug the power cord immediately. Make sure the supplied voltage to the printer matches the rating voltage labeled on the printer. Make sure your outlet works and is not controlled by a wall switch or timer. Turn off the power and make sure the power cord is securely plugged into the printer. When the Operate light does not come on and mechanism initialization does not start (even when the Power button is pressed to turn on the printer), try the solutions listed for the problem. Note the error number "nnnnnnnn" and contact your dealer.
#Canon ip3000 printer turning off by itself install
Install the correct I/F card after turning off the power. Go to Wireless LAN setup and then Press OK. Below are troubleshooting steps you should follow in these circumstances: Press the Setup button on the printer. Install or attach the maintenance tank again. In most cases (with wireless printers), the communication issue is the reason behind the Canon printer not responding. Maintenance tank is not installed or not attached correctly. Ink cartridge(s) is (are) not installed or not attached correctly. Wrong ink cartridge(s) is (are) installed. Install ink cartridge(s) as indicated by the lights. Replace the ink cartridge(s) as indicated by the lights. When an error or status message appears again, clear and perform printing a test pattern again. Press the Pause button to exit the SelecType mode. If an error occurs, or the ink lever is at the up position, you try to print a test pattern (nozzle check, status check, head alignment, or paper thickness pattern) from the SelecType settings.Īfter 3 seconds the message disappears. Push the paper lever down to remove the paper. Loaded paper is too thick for head cleaning. Start printing again from the beginning for best results. Set the paper lever to the secured position. Paper lever was released during the printing process or another operation. See Troubleshooting on the Optional Auto Take-up Reel Unit.
Optional Auto Take-up Reel Unit is not operating correctly.Ĭheck whether the unit is operating correctly.
Paper is set out of the horizontal cutting area.Ĭut the paper at the paper insertion slot, then reload paper. Remove then reload the paper so that the right and bottom edges are straight and in line with the rows of punch holes on the printer. Paper could not be reversed into the printing position. See Paper Feed or Paper Jam Problems Occur Frequently. Slippage occurred and paper was fed at an angle. When RELOAD PAPER is displayed, load paper. See also Paper Feed or Paper Jam Problems Occur Frequently.Ĭut the paper manually, then remove the cut paper from the printer.
#Canon ip3000 printer turning off by itself driver
Make sure the paper source setting in the printer driver is the same as the control panel. The paper source setting in the printer driver is different from the control panel. If this message appears during a print job, reset the printer by pressing the Pause button for 3 seconds, then load paper and send the job again. Remove any printouts or paper remaining in the printer.
0 kommentar(er)
